The Wizard plasma cutting system was developed specifically for the
HVAC contractor/fabricator. It is designed to do all that a user could
want and meet the user’s budget. Nothing has been sacrificed except
cost to our customer.
CUTTING TABLE FEATURES
- Heavy duty 5’X10″; all welded steel construction capable of a 2000 lb. load (full sheet of 1″ plate)
- 2 1/2″X60″, 16ga slats for economical replacement
- Efficient down draft exhaust design, activated & deactivated automatically as cutting starts & stops
- Hinged clean out doors at both ends makes clean out easy. Slat removal not necessary.
- Top quality Browning 3/4″ rack & pinion drives.
- The finest dual hardened and ground HIWIN#20 linear guide ways
- Heavy duty NEMA 34 motors that automatically square the gantry (a feature only found on the best cutting tables)
- Direct drive, high torque motors to eliminate position error found on belt driven tables
- Solid 4’X6″ thick wall tube gantry. this light weight, rigid construction means less moving weight and maximum repeatability
- Gantry drive with 3/4″ rack & pinion and dual hardened & ground HIWIN#15 linear guide ways.
- Top quality motors and gears delivering position repeatability of approx. 0005″
- Gantry capable of speeds of 10001pm
- Precision Drop Heat Control
- Torch crash protection
- The Wizard plasma cutting system was developed specifically for the small to medium size
HVAC contractor.
The Wizard is a full featured machine with all the capabilities of the more
expensive plasma cutting systems, however, it is affordably priced.
MADE IN THE USA!!
